Ftdi Driver Install

14-05-2021 admin

Right-click the FTDI device and choose “Update driver software” Choose that you’ll browse for the driver yourself: Find the folder of AmbiLED HD that you’ve downloaded: Choose the folder “FTDI USB Drivers” and click OK, then click “Next” in the Wizard. Choose “Install”. This should be the final step in the wizard. FTDI driver install I need to install the FTDI driver on wyse C30LE with CE 6.0 OS I tryed to follow the steps from FTDI, but I get error 87 when I. USB RS232 - FTDI designs and supplies USB semiconductor devices with Legacy support including royalty-free drivers. Application areas include USB RS232, ( USB Serial ), USB Parallel, USB Docking Stations, and upgrades of Legacy designs to USB.

Hi,

Thank you for posting your question in the Microsoft Community.

I can understand that it must be difficult for you when things are not working as it should. Sorry to know that you are facing this issue.

Please answer these questions to get more clarity on this issue:

Did you make any changes to the pc prior to this issue?
Have you installed all pending updates on the pc?
Is the issue specific to this driver?

You may boot the computer in a clean boot state and check if the issue persists. When you start Microsoft Windows, typically there are several programs that start automatically and run in the background that may interfere with the system. These programs may include antivirus and system utility programs. When you perform a clean startup procedure, you prevent these programs from starting automatically.

How to troubleshoot a problem by performing a clean boot in Windows: (Applies to Windows 10) http://support.microsoft.com/kb/929135

Note: After you have finished troubleshooting, follow the steps under “How to reset the computer to start as usual after troubleshooting with clean boot” in the article to boot to normal startup.

Review Windows Update. The Windows Update service is a key item to review. Windows Update may have updated drivers available that may be relevant to your current issue. Many times, updated drivers are listed in the 'Optional' section of Windows Update. Install any pending updates on the pc to check if that helps.

Keep us informed to help you further.

In this step, you will run two installers to enable USB features between your Intel® Edison board and your Windows* computer.

Ftdi Driver Silent Install

Install the Intel® Edison Board USB Drivers
Run the standalone driver installer for Windows* to install several USB drivers such as:
- Composite Device Class (CDC) for programming the board via the Arduino* IDE
- Remote Network Driver Interface Spec (RNDIS) for Ethernet over USB
- Device Firmware Upgrade (DFU) for updating firmware on devices
Install FTDI* CDM drivers
Install serial drivers, available from FTDI Chip*, to allow your computer to communicate with USB serial devices, including the Intel® Edison board.

Are you running Windows* 64-bit?
You will find it more convenient to use the setup tool to install all USB drivers (plus flash firmware) within a single installation wizard. Go to the Windows* 64-bit Getting Started Guide.

Install the Intel® Edison Board USB Drivers

Get the latest Windows* Standalone Driver from software.intel.com/iot/hardware/edison/downloads listed under the driver software heading.
Direct file link:
At the time of writing, the latest Windows* Standalone Driver was 1.2.1.
Double-click the downloaded EXE file to launch the installation wizard.
Follow the on-screen instructions within the installer. Click Next where needed.

Install FTDI CDM Drivers

Download the FTDI* D2XX drivers setup executable for Windows* from ftdichip.com.
Direct file link:
At the time of writing, the latest Windows* setup executable was 2.12.26.
Extract the files from the downloaded ZIP. Right-click the downloaded EXE file and select Run as administrator.
Follow the on-screen instructions within the installer. Click Next where needed.
Once installation is complete, reboot your system.